.Role: Civil EngineerLocation: Madrid, SpainDuration/End: September 2025 (Possible Extension)Rate/Package: $NegotiableProject phase: Detail DesignProject Scope of Work :The scope of work consists of design, supply, installation, and commissioning of:Three gas compression facilities in the Jafurah area (THRY GCP-5, THRY GCP-9, and HZEM GCP-6). Each GCP will produce 200 MMSCFD of raw gas and a total of 215,230 BPD condensate.Produced Water Injection Station will receive around 100,000 BPD of produced water from each GCP.Job PurposeThe candidate must lead, review, assess and manage scope of works of the allocated FEED/EPC package under the direction of their delegated Senior Project Engineers and Project Manager. The candidate must also review, participate, guide and manage the FEED/EPC contractor in developing the scope of works as defined in the various Work Entity Releases (WER's) (relevant to the FEED phase).Key Responsibilities and DutiesSupervision of civil and structural engineering execution in detailed design, production of calculations for heavy equipment foundations, buildings and steel structures.EPC/FEED Analysis and design of modular steel structures including sea transportation, lifting analysis, skidding analysis, load out and stress analysis.EPC/FEED Design of structural steel and precast pipe racks.EPC/FEED Design of structural steel technological structures, process plant structures.EPC/FEED Design of blast resistant buildings.EPC/FEED Design of compressor/table top, pumps and similar types of machine foundations.EPC/FEED Design of Equipment foundations like exchangers, coolers, process columns, steel stacks, horizontal vessels, pipe supports.EPC/FEED Design of specialist structures like chimneys, natural draught cooling towers, pre-stressed bridges, arch bridges.Conversant with all the international design codes of practices such as American and British codes, International Building Code (IBC).Responsible to plan and conduct independent work requiring judgement in the evaluation, selection, application and adaptation of engineering techniques, procedures and criteria.Review drawings, specifications and calculations and monitor work for compliance to applicable codes, accepted engineering practices and standardsCoordinate the design effort to support the materials requisitions and ensure these documents comply with the technical project specifications.Analyze disputed item from technical and contractual aspects and prepare required official response.Responsible for processing and following up change orders requests. Preparing required Justification Work Sheet, Issuing Change Order Request to Contractor and lead scope alignment process with Contractor